AICS Installation for Remington 700 Short Action

First of all a disclaimer, I am not a professional gunsmith and so this is just my way of how I did things with this upgrade.

I started off with a stock Remington 700 straight from the box bar the scope and other accessories as shown here.

 

First things first as before starting any work on a firearm you should always check that firearm is unloaded, I do this by cycling the actions several times and visually checking the chamber, as can be seen in the photo below this chamber is clear.

 

 As this is a bolt action firearm, for further safety I removed the bolt during the process

The first step in getting the stock upgraded is of course removing the accessories where appropriate and of course old stock, and a quick look at the exploded diagrams in the manual show how to do it.

Firstly as shown here I removed the bipod off the front of the rifle as seen here it is removed. Due to the way that the 700 series is assembled I opted to leave the scope mounted to the rifle.

With the 700 Series it’s a simple 2 screws from the bottom of the rifle under the magazine release and trigger guard. I unfortunately did not take a photo of this, but looking at the AICS install photo to see the location of the bolts.

Once the two bolts are removed the action and barrel simply separates from the stock as shown below.

Something that the kit requires for installation is that the trigger pins be in the proper location flush with the assembly  which as shown here they are

 

 

Once this is done the receiver/barrel/trigger assembly is installed in the stock and torqued to the correct setting using a torque wrench (which is not photographed)

Once torqued up its ready to go, although for the most part you will need to re-sight your scope, in my case I also have to raise the scope up as with the cheek rest it is too low for me to use to this end I will be putting a 20 or 25MOA picatinny on the top and getting higher rings which will allow for a greater scope height which I need.

Shown below is the completed stock with both the 5 and 10 round magazines, along with a comparison photo of the size of the 2 magazines.

 

 

 

In conclusion this is a great stock and I believe firmly believe will honestly increase the usability of the rifle.

Pros

  • More Comfortable
  • Thumbhole Grip

Cons:

  • Heavy
  • Reduces scope height in relation to the cheek rest

Rating: 9/10

References:

http://www.accuracyinternational.com/aics_kits.php

Written By Justin

Leave a Reply

Your email address will not be published. Required fields are marked *

four × 1 =